I've had two occasions in the last 2 days where I try to dial a number and it never properly connects. It acts like it's dialing, once says it was connected, but it never really does anything. I realize that sometimes it takes a while (20-30 seconds) to actually connect, but this seemingly never does anything for well more than that. I have bluetooth turned on, but I'm not actually connected to a headset, so I guess it's possible that it's rerouting the audio and I have no way of hearing it. The only way I've gotten out of the problem each time is by soft-resetting. Anyone else having this problem? I'm on the no junk AKU 3.5, and have been for quite some time, but this problem just surfaced. Honestly, I can't tell if it's a phone software problem or if Sprint itself is having a problem, but it does immediately correct itself after a reset, which makes me suspect the phone. Any ideas?

I've had that happen on my 3.5 AKU Sprint phone too. Don't even bother resetting it. Whenever it hangs on me I just hang up and redial. Check to see the level of signal you have on the phone. Usually happens in a crappy signal area for with my 6700.

I don't doubt that I could have been in a crappy signal area, but on these 2 occasions hanging up and re-dialing didn't do any good either, which is why I reset the phone - and then it worked fine. I didn't have the problem yesterday so I guess I'll just see how often it happens now.

Pocket Pcs tend to act buggy sometimes. Soft resets usually do the trick.