I just switched from a 6600 to an XV6700 (warranty) from Verizon. Great PDA.

HOWEVER I AM A LITTLE FAR SIGHTED!

The size of the dialing key pad is much smaller and I can't see it or the incoming call now without glasses.

Because it is a warranty repacement, I am stuck with it (perfect PDA otherwise). Is there any way to increase the size of the GUI DTMF keypad?

I am a neophite at the registry, etc. I would be so grateful. I will even pay someone to write the code if necessary.

Thank you in advance!

Robert

I know this is a long post, but check out here: http://pdaphonehome.com/forums/ppc-6...ghlight=dialer

There are some links in the first couple of pages of someone who has made some dialers. They are on his site. I use one of the Black ones. The buttons are about 75% bigger.

__________________
Bryan

"I'm not going anywhere NEAR that sabertooth snatch of yours." - Dr. Christian Troy

Thank you! You truly have made my day! By any chance do you know which programmer it was? There appear to be a few indicated.

Jakaroe808

__________________
Bryan

"I'm not going anywhere NEAR that sabertooth snatch of yours." - Dr. Christian Troy

BTW Does your skin have the SmartDial version?

No. I personally don't like it. It slows down the dialing.

I have MS Voice Command so I use that to dial contacts.

__________________
Bryan

"I'm not going anywhere NEAR that sabertooth snatch of yours." - Dr. Christian Troy

Bryan,

I hooked it up. Again, thank you! I can see it without glasses and now I am implicitly pleased with this phone thanks to you.

Love and light

I sent Pauly a payment as well. Thanks again.

No problem

__________________
Bryan

"I'm not going anywhere NEAR that sabertooth snatch of yours." - Dr. Christian Troy