I've noticed recently that if I am using the cell phone portion of my 6700, once the call has ended, the broadband becomes active. This becomes a problem because if I lose a call and the caller calls back, it immediately goes to VM because the broadband service is active (I do not have EV-DO in my area yet). It is not performing a VZW sync, that much I am sure of. I searched around in the registry hack section but other than that, I couldn't really find what I was looking for. Does anyone have any suggestions?

I'm seeing this too, I get an error 32 after a call and I have to turn on and off the radio(cell) signal before I can then use EVDO again. Anyone else?