|
Phone attempted suicide today....
So I get back from an early day at work. Toss the phone on the bed like I always do, except instead of the usual thwump, and I rattle-rattle. Eh? Figuring the case was rattly I pick it up and shake it. Rattle rattle, take it out of the base, rattle-rattle. Damn. Check the screws on the outside, all were there. Damn. I kept rattling it for about 5 minutes ttrying to figure out what it was, no idea. Decided to take it apart and look around. Pop the battery off, remove the stylus, rattle-rattle. Take out the screws and open the case, and find a loose screw. It was one of the screws the holds the memcard/camera assembly to the mommyboard. Luckily, it was the one near the battery, in the outer case, where it drops down to make the edge where the battery butts up. If that little 90 degree edge wasnt there it would have danced across the motherboard, causing problems I'm sure (like what happened to my old laptop).
Luckily the threads weren't stripped, it went back in tight, then I proceeded to check all the other screws. Everything else was fine. Dunno what made that screw decide to come out.
Also, because of this I confirmed something I suspected, that my backup battery inside the phone is useless. Phone was without any power for about 7 minutes, and upon turning it back on, everything was lost. Good thing I did a clone of it yesterday.
Just thought I'd share with the few other 'screw small screens' guys on here.
__________________
Sprint Mogul (PPC-6800) - dcd 3.0.1 ..... 3.35.04 ..... OliPro 2.40 ..... 60610 PRL
Sprint PPC-6600 - 2.07.00 WWE ..... HA00_166 (spare phone laying around)
Sprint PPC-6600 - 2.04.00 WWE ..... HA00_140 ..... 1.36.113 WWE (used for GPS only)
|
|