Guys I found another way on how flsh the phone yourself... and here is the Guide step by step.
Flash the phone on your own risk
(gigi said- i have slightly changed those instructions after doing it myself.....)
Things you need:
Motorola USB Data Cable.
Download Motorola PST 6.0 or higher form
Here and the patch from
here.
After you have downloaded the files and installed them you'll need to get the new firmware for your phone look around the net for it.. it should go like this "REL_30.80.15_SE8111AC3W8_001_BP" thats the file name.
Now follow the steps -
Download the NEW 6.7 (& the patch Install PST 6.7 with the windows updates it comes with + patch.
Flash Image (.shx )
1. Uninstall your A920 desktop suite. (not needed on my pc).
2. Install Motorola PST 6.0 or higher.
3. Remove the SIM, battery and SD card from your phone.
4. Hold down the 2 game buttons.
5. Whilst holding the 2 game buttons down, plug in the power with USB cable into your phone. (make sure the USB cable is connected to a different USB port than the one you used before...especially if u use a laptop)
6. Release the 2 game buttons. (Your phone should say "AP is on CE-Bus, Waiting for PST")
7. Windows will go ballistic and pick up a new device. The drivers are under the PST installed directory.
8. Open the "PST Flash and Test Commands" program.
9. Now in PST program click on the "Motorola P2K Device" (bottom left) and you should see info in the
phone information section of the screen.
10. Click on "browse" choose your BP Flash file. (you will need to make sure the flash file is unzipped first).
11. Once it's loaded you should see a bunch of data in the flash load section.
12. Klick Flash
13. The flash will begin then fail horribly - don't worry this is normal.
14. Windows will start redetecting your phone. And the PST will tell you that the process has failed and will ask for a new device/flash – answer no and close the PST program... (don’t worry, it's safe to restart the PST program each time....trust me)
15. Point windows installer to grab the new device drivers from your
PST directory. (note that this time the driver’s name is different…)
16. After the drivers is installed relog your phone (like in steps 5-6), you will need to take your phone off the cradle and reinsert it again (dot worry its normal…)and then start the PST program again.
17. Repeat steps 9 to 12. (you might need to repeat it for several times…)
18. The flash should go through now. once again DON'T TOUCH IT, don't even look at your phone in a bad way.
19. The flash takes a while 4-6 min as far as i remember. So wait for it. Don’t be alarmed if it takes longer…
20. if this time windows did not detect a new device and you didn’t get any error messages, once you get the “flash another phone?” message, you are done! Click no
21. Unplug the phone from the USB and power cable and slide your sim, battery and SD card back in and restart your phone.
p.s- once flashing your phone, you will lose any information you had on it, so make sure you perform a backup before you flash it
also, if you had the basic A920 you will need an updated version of the desktop suite, otherwise it wont work (A925 desktop suite is recommended)
this version might not be suitable for A925 phones, so wait for us to test it before you try it on this phone…….either way, YOU DO IT ON YOUR OWN RISK!!!
Good Luck
Aussie_Tank and Gigi…….
How To Flash Your Phone Yourself
Login
Panel
