Except for my info loss problem, only one problem left with this phone, and its a 100% functioning phone with no other problems.

The "0" button does not work well unless you press down hard on it.

Hoes the hard keys come away from the board? Is there any way to clean the contacts under the keys and get the life back in my "0" button again?



thanks in advance

Yes, but you'd have to completely disassemble the lower half of the clam shell. Before doing that I would first try to tighten the six screws that hold the lower clam shell together and see if that helps (two of the screws are located underneath the back part of the lower shell, so you have to remove the other four screws and pull off the back part of the shell before you can get to them).

If you feel comfortable taking it apart, cleaning the contact does the trick.

http://pdaphonehome.com/forums/kyoce...ive-0-key.html

Thanks, I will check that out.

Thanks for the link, I am a little embarrased now. Didnt think it was a common problem