It's been a while I search the photos I have them a hard drive but its sitting on a shelf. Seeing as there are like a dozen drives on the shelf I am not sure which on they are on.

In the past I opened a few of these and they are not hard to work on.

The silver metal trim cover can be removed by heating it with a blow dryer to soften the glue you can then use a razor blade to seperate the trim from the cover. Under the trim you will find a couple of screws.

Just take your time after screws are removed use a credit card to pry open the cover. Not sure if screws are torex or phillips.

The ribbon cables are held in the connector by locks on either side of the connector just push up on them using your finger nail or a small screw driver.

I did find I needed to put double sided tape on the back of the LCD between the lcd and the back cover on one of the phones I repaired. This was the only wayI could get the lcd to display. With out the tape It was very dull not sure why but the tape worked.

Good luck